First you need connect the ford vcm with the car ,plug the obd cable Inside the car obd port,
Connect the usb with laptop (the software should ready for use)
Check The local area connection already build and ready for use
When you connect everything ok .the led light will flashing (number 2 and number 5 led light will keep flashing)
And then we need click the ids icon on the laptop desk .
If it is your first time use the ford vcm .you have to connect the car,ford vcm device ,
When it coming out the dialog box,choose the deletes session .then we will enter the diagnosis page .
If you are the first time use this ford vcm ,look at the lower right corner
The green light icon means the engine is on(make sure the engine is on,it’s very important) ,it also show you the ford vcm little icon,it means the ford vcm is connection
We need choose start new session,and click all other ,then choose yes.next buit the connection,
Few seconds later .it will coming out vehicle built before march 2008 .the car model is new ,
So choose “NO”
And the VIN code is correct ,click yes .systerm now is connection
Then waiting for a while ,the page show you odometer ,and then click the green button ,mean yes ,
Then it will show you the car information,
You can found one more icon on the page ,that means ford diagnosis ,click the last icon on the top of the page ,choose the electrical ,then choose the exterior lighting ,then we choose the data link monitor ,then we can check out the fault code on the laptop for the ford car.
Turn on the car light ,the park_sw is on ,when you turn off the car light ,the park_sw is off,
After these steps ,it can prove our device ford vcm work perfectly
If you think this article help you, please click on the “Like”,if you have any other question ,
pls contact with us here www.facebook.com/Myobdii tell us your issue.
Learn more at: